You have no items in your shopping cart.

Search
1 800 661 1801

Janome 7700 Threading

•  Turn the power switch on, and raise the needle by pressing the up/down needle position button
•  Raise the presser foot
•  Turn the power switch off
•  Draw the thread from the spool
•  Pass the thread down in to the guide slot
•  Draw the thread around the corner and towards you along the channel
•  Pull it down along the right channel
•  Pull the thread up around the guide plate and along the left channel
•  Slip the thread in to the eye of the take-up lever and pull it down along the left channel
•  Pass the thread through the thread guides under the face plate and needle clamp

Needle threader:

•  Turn the power switch on and press the up/down needle position button twice, to raise the needle
•  Turn the power switch off and lower the presser foot
•  Pull the threader down as far as it will go
•  The hook comes out through the needle eye and the threader is held in the down position
•  Draw the thread and pass it around the left guide
•  Draw the thread to the right and under the threader hook
•  Hang the thread on the right guide
•  Raise the threader slowly, drawing the thread loop through the needle eye
•  D
raw the thread end out through the needle eye